ENGLISH
28
2. Slide the pilot pin through the hole in the center
of the cutter shank.
3. Turn the tool holder locking sleeve (aa)
clockwise and hold it in position.
4. Insert the shank of the accessory (bb) as far into
the tool holder (f) as possible.
5. Release the locking sleeve.
6. Twist the accessory until it locks in position.
7. To remove the accessory, twist the locking
sleeve clockwise and take out the cutter.
Setting the Speed (fi g. 7)
The machine is equipped with a 2-gear selector to
vary the speed/torque ratio.
1. Depress the slider (cc) in order to change the
gear.
–
Slide the slider (cc) up for low speed and high
torque (holes from 32 to 50 mm).
–
Slide the slider down for high speed and low
torque (holes from 12 to 30 mm).
2. You may have to rotate the tool holder slightly
before the gear engages.
WARNING:
Do not change gears at full
speed or during use.
Prior to Operation
Try a few simple projects using scrap material until
you develop a “feel” for the machine.
OPERATION
Instructions for Use
WARNING:
Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
•
Apply only a gentle pressure to
the tool. Excessive force does not
speed up drilling but decreases tool
performance and may shorten tool life.
•
If the accessory jams, stop the motor
and gently raise the accessory out of
the workpiece before resuming work.
• Always use the safety strap.
• Always use the drill guard.
Turning On and Off (fi g. 1, 8)
In order to operate properly, the machine has to
be turned on following the procedure as described
below.
TURNING THE POWER ON AND OFF
Connect the machine to the mains. The power
indicator (dd) will blink.
To turn the power on, press and hold the on/off
button (a) for 1 second. The power indicator will stop
blinking and will remain on.
To turn the power off, press and hold the on/off
button for 1 second. The power indicator will start
blinking until the mains plug is disconnected.
ACTIVATING THE MAGNET
The magnet can only be activated when the power
is turned on.
To turn on the magnet, press the yellow button (b).
The yellow indicator (ee) goes on.
To turn off the magnet, press the yellow button
again. Before releasing, the magnet will remain
engaged for 3 more seconds, which is indicated by
the yellow indicator blinking until it goes off.
TURNING THE DRILL MOTOR ON AND OFF
The drill motor can only be switched on when the
magnet is activated.
To turn the drill motor on, press the green button (c).
The green indicator (ff) goes on.
To turn the drill motor off, press the green button
again. The indicator goes off.
RE-SETTING THE MACHINE
If the power is interrupted during use, or if at any
point the magnetic seal is broken, the machine must
be reset.
1. Turn off the drill motor first, and then the
magnet.
2. Ensure that the work area is clean.
3. Turn on the power.
4. Activate the magnet.
Drilling a Hole (fi g. 1)
1. Always apply an appropriate cutting
fluid/ coolant on the cutting area.
2. Lower the guard (g) so that it screens the
surface to be drilled.
3. Make sure the drill point or cutter pilot is
properly installed over the spot to be drilled.
4. Turn on the drill motor.
