DeWalt D25580, Manual

ENGLISH

6

Residual Risks

In spite of the application of the relevant safety 

regulations and the implementation of safety 

devices, certain residual risks cannot be avoided.

These are:

Impairment of hearing.

Risk of dust inhalation.

Risk of personal injury due to prolonged use.

Risk of burns due to accessories becoming 

hot during operation.

Markings on Tool

The following pictograms are shown on the tool:

DATE CODE POSITION

The Date Code, which also includesthe year of 

manufacture, is printed into the housing.

Example:

20

13

 XX XX

Year of Manufacture

Package Contents

The package contains:
1 Heavy-duty demolition hammer 
1 Side handle 
1 Pointed chisel

(for -B1,-XD)

1 Kitbox
1 Instruction manual
1 Exploded drawing
1 Warranty card

Check for damage to the tool, parts or 
accessories which may have occurred during 
transport. 
Take the time to thoroughly read and 
understand this manual prior to operation.  

Description (fig. 1)

WARNING: 

Never modify the power tool 

or any part of it. Damage or personal 
injury could result. 

–

–

–

–

Read instruction manual 

before use.

Wear ear protection.

Wear eye protection.

•

•

a.

b.

c.

d.

e.

Side Handle 

Switch

Barrel cover

Tool sleeve

Dust cap

INTENDED USE

Your demolition hammer has been designed for 

professional light or medium chipping, chiselling 

and demolition applications in concrete, brick and  

masonry.

DO NOT 

use under wet conditions or in presence 

of flammable liquids or gases.

These demolition hammer are professional power 

tools. 

DO NOT

 let children come into contact with the 

tool. Supervision is required when inexperienced 

operators use this tool.

Electrical Safety

The electric motor has been designed for one 

voltage only. Always check that the power supply 

corresponds to the voltage on the rating plate.

Your D

E

WALT tool is double insulated in 

accordance with EN 60745; therefore no 
earth wire is required.

If the supply cord is damaged, it must be replaced 
by a specially prepared cord available through the 
D

E

WALT service organization.

Using an Extension Cable

An extension cord should not be used unless 
absolutely necessary. Use an approved extension 
cable suitable for the power input of your tool (see 
technical data). The minimum conductor size is 1 
mm

2

; the maximum length is 30 m.

When using a cable reel, always unwind the cable 
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of 
injury, turn unit off and disconnect 
machine from power source

before 

installing and removing accessories, 
before adjusting or changing set-ups or 
when making repairs. Be sure the trigger 
switch is in the OFF position. An 
accidental start-up can cause injury.