ENGLISH
47
Brush Inspection
For your continued safety and electrical protection,
brush inspection and replacement on this tool should
ONLY be performed by a
D
E
WALT factory service
center, a D
E
WALT authorized service center or other
qualified service personnel
.
At approximately 100 hours of use, take or send your
tool to your nearest D
E
WALT factory service center or
D
E
WALT authorized service center
to be thoroughly
cleaned and inspected. Have worn parts replaced
and lubricated with fresh lubricant. Have new brushes
installed, and test the tool for performance.
Any loss of power before the above maintenance
check may indicate the need for immediate servicing
of your tool. DO NOT CONTINUE TO OPERATE TOOL
UNDER THIS CONDITION. If proper operating voltage
is present, return your tool to the service station for
immediate service.
Waxing Motor and Base
To maintain a smooth action when moving the
motor unit in relation to the base, the outside of the
motor unit and the inside of the base can be waxed
using any standard paste or liquid wax. Per the
manufacturers instructions, rub the wax onto the
outside diameter of the motor unit and the inside
diameter of the base. Allow wax to dry and buff off
residue with a soft cloth.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING:
Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING:
Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Optional Accessories
WARNING:
Since accessories, other
than those offered by D
E
WALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
E
WALT, recommended
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
E
WALT product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products and
packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D
E
WALT provides a facility for the collection and
recycling of D
E
WALT products once they have
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D
E
WALT office at the address indicated in this
manual. Alternatively, a list of authorised D
E
WALT
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com
.
Summary of Contents for D26200
