E N G L I S H
26
Sanding (fi g. A)
Start with the coarsest grit size.
As the tool produces small scratch marks in all
directions, it is not necessary to sand with the grain.
Check your work at short intervals.
Always switch off the tool when work is finished and
before unplugging.
Replacing the Dustbag (fi g. E)
For efficient dust extraction replace the dustbag
when it is about one third full.
1
. Carefully pull the dustbag opening (12) off the
frame outlet (13) and remove the dustbag (8).
2.
Fit a new dustbag following the instructions as
described above.
MAINTENANCE
Your D
E
WALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs.
Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Replacing the Sanding Pad and the
Speed Limiter Disc (fi g. F)
Both the sanding pad (5) and the speed limiter
disc(15) are consumable parts. The sanding pad
needs replacement when signs of wear become
evident. The speed limiter disc needs replacement
when the sanding pad speed increases dramatically
when lifting the sander off the workpiece.
1.
Unplug the tool.
2.
Loosen the hex screw (14) and remove the pad.
3. Replace the sanding pad (5) and/or speed
limiter disc (15), and tighten the Hex screw (14),
making sure the speed limiter disc is aligned
properly.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING:
Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING:
Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
•
After the tool is used in metal sanding
applications without dustbag, clean the tool
using low-pressure air.
Optional Accessories
WARNING:
Since accessories, other
than those offered by D
E
WALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
E
WALT, recommended
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
E
WALT product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Summary of Contents for D26410
