3
causing fire or explosion. If spraying flammable
materials, locate compressor at least 20 feet up wind
from spray area. An additional length of hose may be
r e q u i r e d .
Store flammable materials in a secure location away
from compressor.
Restricting any of the compressor ventilation openings will cause
serious overheating and could cause fire. Never place objects against
or on top of compressor. Operate compressor in an open area at
least 3 feet away from any wall or obstruction that would restrict the
flow of fresh air to the ventilation openings.
RISK FROM FLYING OBJECTS
The compressed air stream can cause soft tissue damage to exposed
skin and can propel dirt, chips, loose particles and small objects at high
speed, resulting in serious injury. Always wear ANSI Z28.1 approved
safety glasses with side shields when using the compressor. Never
direct air stream at people or animals. Use only OSHA approved air
blow guns.
RISK TO BREATHING
The compressed air from your compressor is not safe for
breathing! The air stream may contain carbon monoxide,
toxic vapors or solid particles. Never inhale air from the
compressor either directly or from a breathing device
connected to the compressor.
Sprayed materials such as paint, paint solvents, paint
r e m o v e r, insecticides, weed killers, etc. contain harmful vapors and
p o i s o n s. NOTE: Operate air compressor only in a well ventilated area.
Read and follow the safety instructions provided on
the label or safety data sheets for the material you are
spraying. Use a NIOSH/MSHA approved respirator
designed for use with the specific application.
RISK FROM MOVING PARTS
The compressor is designed to run continuously.
Always turn off the compressor, bleed pressure from the air hose and
tank, and disconnect from power source before performing
maintenance or attaching tools and accessories.
Keep your hair, clothing, and gloves away from moving parts. Loose
clothes, jewelry, or long hair can be caught in moving parts. Air vents
may cover moving parts and should be avoided as well. Do not
remove the protective covers from this product. Never operate
compressor with guards or protective covers that are damaged or
COMPRESSOR
CYLINDER & HEAD
PUMP
CRANKCASE
GASOLINE
ENGINE
HOT SURFACES
COMPRESSOR
CYLINDER & HEAD
AFTERCOOLER
PUMP
CRANKCASE
ENGINE
MUFFLER
ENGINE
HEAD
HOT SURFACES
ENGINE
MUFFLER
AFTERCOOLER
Gas Manual 10-5-01 2/10/03 2:31 PM Page 3
