10
English
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement) should
be performed by a D
e
WALT factory service center, a D
e
WALT
authorized service center or other qualified service personnel. Always
use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
•
Warranty SerVICe:
Registering your product will help you
obtain more efficient warranty service in case there is a problem
with your product.
•
ConfIrMatIon of oWnerSHIp:
In case of an insurance
loss, such as fire, flood or theft, your registration of ownership will
serve as your proof of purchase.
•
for your Safety:
Registering your product will allow us to
contact you in the unlikely event a safety notification is required
under the Federal Consumer Safety Act.
Register online at www.dewalt.com/register.
Three year Limited Warranty
D
e
WALT will repair, without charge, any defects due to faulty materials
or workmanship for three years from the date of purchase. This
warranty does not cover part failure due to normal wear or tool abuse.
For further detail of warranty coverage and warranty repair information,
visit www.dewalt.com or call 1-800-4-D
e
WALT (1-800-433-9258).
This warranty does not apply to accessories or damage caused where
repairs have been made or attempted by others. This warranty gives
you specific legal rights and you may have other rights which vary in
certain states or provinces.
Replacing Belt (Fig. 9, 10)
Follow the instructions below to replace the blower belt on the unit
or bring the blower to a D
e
WALT factory service center, a D
e
WALT
authorized service center, or other qualified service personnel. Always
use identical replacement parts.
1. Remove battery and slide the lock-off switch to the locked
position.
2. Remove the four belt cover screws (9A) from the belt housing
and remove the belt cover (9B) as shown in figure 9.
3. Pull the belt (10A) off from the bottom wheel shown in figure 10.
Once off it will easily slide out of the top.
4. Wrap the new belt around the top wheel and pull it down over the
bottom.
5. Replace belt cover.
6. Replace belt cover screws.
FIG. 10
10A
FIG. 9
9A
9B
Accessories
WARNING:
DO NOT use the blower with
any type of accessory or attachment. Such usage might be
hazardous.
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
