English
9
holder, slide the flat head of the chuck key handle into the
chuck key holder
10
as shown. Snap the handle's shaft into
the retention clip
11
on the holder.
To remove the chuck key from its holder, pull the chuck key
handle out of the holder and slip the flat head out of the hole.
nOTE:
To avoid losing the chuck key, do not store it in any
other orientation.
Fig. F
10
6
11
6
Installing and Releasing a Bit (Fig. A)
Open the keyed chuck jaws by turning the collar by hand
then insert the shank of the bit about 3/4" (19 mm) into
chuck. Tighten the chuck collar by hand. Place chuck
key (
6
, Fig. A) in each of the three holes, and tighten
in clockwise direction. It’s important to tighten chuck
with all three holes. To release the bit, turn the chuck
counterclockwise in just one hole, then loosen the chuck
by hand.
nOTE:
When using hex shank or three-sided shank bits, be
sure to align the flat sides of the bit with the chuck jaws to
ensure the bit is properly engaged by the jaws.
Worklight (Fig. A)
CAUTION: Do not stare into worklight.
Serious eye
injury could result.
The worklight
7
is activated when the trigger is depressed,
and will remain on for a short time after the trigger is
released. If the trigger remains depressed, the worklight will
remain on.
nOTE:
The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
D
e
WALT Bluetooth® Tool Tag Ready
(Fig. A, G)
Optional Accessory
WARNING:
Read instruction manual for the
D
e
WALT
Bluetooth
®
Tool Tag.
WARNING:
Remove battery from tool before installing
the
D
e
WALT
Bluetooth
®
Tool Tag.
WARNING:
When installing or replacing the
D
e
WALT
Bluetooth
®
Tool Tag, use only the screws provided. Be
sure to securely tighten the screws.
Your tool comes with mounting holes and fasteners
12
for
installing a
D
e
WALT
Bluetooth
®
Tool Tag (DCE041). You will
need a flat-blade screwdriver to install the tag. Screw torque
should be between 0.8 and 1.2 Nm (7.1 to 10.6 in-lbs). The
D
e
WALT
Tool Tag is designed for tracking and locating
professional power tools, equipment, and machines using
the
D
e
WALT
Tool Connect™ app. For proper installation of
the
D
e
WALT
Tool Tag, refer to the
D
e
WALT
Tool Tag manual.
To learn more, visit:
www.
D
e
WALT
.com/en-us/jobsite-solutions/tool-connect
Fig. G
12
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories.
An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. H)
nOTE:
For best results, make sure your battery pack is
fully charged.
To install the battery pack
1
into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
2
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
