EnGLIsH
3
9
•
Apply pressure only in direct line with the bit and do
not apply excessive pressure. Bits can bend causing
breakage or loss of control, resulting in personal
injury.
Additional Safety Warnings for Drill/
Driver/ Hammerdrill
•
Use clamps or other practical way to secure and
support the workpiece to a stable platform. Holding
the work by
hand or against your body is unstable and may lead
to loss of control.
•
Accessories and tool may get hot during operation.
Wear gloves when handling them if performing heat
producing applications such as drilling metals.
•
Air vents often cover moving parts and should be
avoided. Loose clothes, jewelry or long hair can be
caught in moving parts.
•
Wear safety goggles or other eye protection.
Hammering and drilling operations cause chips to fly.
Flying particles can cause permanent eye damage.
•
Wear ear protectors when impact drilling. Exposure
to noise can cause hearing loss.
•
Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
•
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a “live” wire may make exposed
metal parts of the power tool “live” and could give
the operator an electric shock.
•
Do not operate this tool for long periods of time.
Vibration caused by tool action may be harmful to
your hands and arms. Use gloves to provide extra
cushion and limit exposure by taking frequent rest
periods.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety devices,
certain residual risks cannot be avoided. These are:
•
Impairment of hearing.
•
Risk of personal injury due to flying particles.
•
Risk of burns due to accessories becoming hot during
operation.
•
Risk of personal injury due to prolonged use.
SAVE
THESE
INSTRUCTIONS
Chargers
D
e
WALT chargers require no adjustment and are
designed to be as easy as possible to operate.
Electrical
Safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also
make sure that the voltage of your charger corresponds
to that of your mains.
Your D
e
WALT charger is double insulated in
accordance with EN62841; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the D
e
WALT
service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
•
Safely dispose of the old plug.
•
Connect the brown lead to the live terminal in the
plug.
•
Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the
earth terminal.
Follow the fitting instructions supplied with good quality
plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
Important Safety Instructions for All Battery
Chargers
SAVE THESE INSTRUCTIONS: This manual contains
important safety and operating instructions for
compatible battery chargers (refer to Technical Data).
•
Before using charger, read all instructions and
cautionary markings on charger, battery pack, and
product using battery pack.
WARNING: Shock hazard. Do not allow any liquid to get
inside charger. Electric shock may result.
Summary of Contents for DCD708
