36
EngLIsh
batteries of 36 Wh each. The Use Wh rating might indicate
108 Wh (1 battery implied).
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOTE:
Battery packs should not be stored completely depleted
of charge. The battery pack will need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See
Technical Data
for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for
the environment.
Charge
D
e
WALT
battery packs only with designated
D
e
WALT
chargers. Charging battery packs other than
the designated
D
e
WALT
batteries with a
D
e
WALT
charger may make them burst or lead to other
dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).
Battery Type
The DCN680 operates on an 18 volt battery pack.
DCB127, DCB181, DCB182, DCB183, DCB183B, DCB184,
DCB184B, DCB185, DCB187, DCB189, DCB546, DCB547, DCB548.
Refer to
Technical Data
for more information.
Package Contents
The package contains:
1 Nailer
3 Non-mar tips
1 Charger
1 Li-Ion battery pack (C1, D1, L1, M1, P1, S1, T1, X1, Y1 models)
2 Li-Ion battery packs (C2, D2, L2, M2, P2, S2, T2, X2, Y2 models)
3 Li-Ion battery packs (C3, D3, L3, M3, P3, S3, T3, X3, Y3 models)
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
nOTE:
N and NT versions are not supplied with batteries or
a charger.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Do not operate tool on scaffoldings, ladders.
Length of nails.
Nail gauge.
Magazine capacity.
Tool voltage.
Magazine angle: 0˚.
Date Code Position (Fig. B)
The date code
18
, which also includes
the year of manufacture,
is printed on the tool foot between the face of the battery and
the nailer.
Example:
2020 XX XX
Year of Manufacture
