5
English
• Avoid cutting nails.
Inspect for and remove all nails from lumber
before cutting.
WARNING: ALWAYS USE SAFETY GLASSES.
Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALWAYS wear certified safety equipment:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3).
• ANSI S12.6 (S3.19) hearing protection.
• NIOSH/OSHA respiratory protection.
WARNING:
Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
•
crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
•
Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction
activities. Wear protective clothing and wash exposed
areas with soap and water.
Allowing dust to get into your
mouth, eyes, or lay on the skin may promote absorption of
harmful chemicals.
WARNING:
Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body. Always operate tool in well-ventilated area and provide for
proper dust removal. Use dust collection system wherever possible.
WARNING: ALWAYS wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use.
Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
WARNING: ALWAYS use eye protection.
All users and
bystanders must wear eye protection that conforms to ANSI Z87.1.
CAUTION: When not in use, place circular saw on a stable
surface, shoe side down, where it will not cause a tripping or
falling hazard.
Some tools with large battery packs will stand upright
on the battery pack but may be easily knocked over.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
A ......................amperes
Hz ................. hertz
W .....................watts
min ............... minutes
or AC ..........alternating
or DC ... direct current
current
................. Class I Construction
or AC/DC ...alternating
..................... (grounded)
........................
or direct
................. Class II Construction
current
(double insulated)
no ....................no load
…/min .......... per minute
speed
BPM ............. beats per minute n
......................rated
IPM ............... impacts per minute
........................
speed
RPM ............. revolutions per
.....................earthing
minute terminal
sfpm ............. surface feet
.....................safety alert
.....................
per minute
symbol
SPM .............strokes per minute
