ENGLISH
41
Camera Cable (fi g. 5)
Align the camera cable (c) with the camera
connector (d). Push in and turn the connector
counterclockwise (camera screen facing you) to
firmly attach.
To remove the camera cable, turn the connector
clockwise (direction of arrow).
Additional camera cable and extensions are available
at additional cost. Consult your dealer for further
information.
Hook and Magnet (fi g. 6)
DCT410
The hook is beneficial for retrieving cable or wire
located in tight spaces. The magnet is beneficial for
retrieving metal objects in tight spaces.
To attach the hook or magnet, turn the knurled part
of the camera counterclockwise until it stops.
Align the hook or magnet with the gray groove (t)
then slide it down until the tabs (u) at the top of the
hook/magnet are securely in the notches (v) located
in the camera lens.
Turn the knurled part clockwise to lock the base of
the hook and magnet.
Hook, Magnet and Mirror (fi g. 7, 8)
DCT411
Follow the process below to assemble the hook,
magnet or mirror onto the DCT411 9 mm camera.
1. With the sleeve (w) on the accessory, insert the
bottom of accessory (bent wire) into the hole (x)
in the 9 mm camera cable.
2. Make sure the accessory is in the groove (y) on
the sleeve and slide the sleeve onto the camera
until the sleeve covers the hole (x).
CAUTION:
Cut Hazard. Use care when
handling hook.
Belt Hook (fi g. 9)
(Optional Accessory)
WARNING: To reduce the risk of
serious personal injury,
DO NOT
suspend camera overhead or suspend
objects from the belt hook.
ONLY
hang
camera’s belt hook from a work belt.
WARNING: To reduce the risk of
serious personal injury, ensure the
screw (z) holding the belt hook is
secure.
IMPORTANT:
When attaching or removing the belt
hook, use only the screw (z) that is provided.
The belt hook (aa) can be attached to either side
of the tool using only the screw (z) provided, to
accommodate left- or right-handed users. If the
hook is not desired at all, it can be removed from
the tool.
To move belt hook, remove the screw (z) that holds
the belt hook in place then reassemble on the
opposite side.
OPERATION
Instructions for Use
WARNING:
Always observe the safety
instructions and applicable regulations.
Inserting and Removing the
Battery Pack from the Inspection
Camera (fi g. 10)
NOTE:
Make sure your battery pack (a) is fully
charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack with the rails inside the
handle.
2. Slide it firmly into place until you hear the lock
snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (bb) and firmly pull the
battery pack out of the camera handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
Getting Started
INITIAL SETUP
Language Setup
1.
Press the forward or back arrow to select
English, German, Spanish, French, Italian or
Dutch.
2. Press the OK button to confirm and exit.
