9
E N G L I S H
en - 1
SURFACING/THICKNESSING ATTACHMENT DE8000
Safety instructions
Observe the safety regulations in the instruction manual of the Power
Tool to be connected to this attachment. Also observe any applicable
additional safety rules. Read the following safety instructions before
attempting to operate this product.
Keep these instructions in a safe place!
The attention of UK users is drawn to the “woodworking machines
regulations 1974” and any subsequent amendments.
General
• The attachment must be level and stable at all times.
• Keep the work top clear of foreign objects.
• Use the attachment with the Power Tools and accessories specified in
this manual only.
• Secure the Power Tool carefully.
• Work with closed hands.
• Make sure that your work area is properly lighted.
Surfacing/thicknessing
1 Dust extraction
As the planer produces dust and chips, the use of dust extraction
equipment is recommended. Proper dust extraction is especially
important if beech or oak dust is produced.
2 Wear safety goggles
Also use a face or dust mask to protect against dust or flying particles.
3 Protection devices
Only operate the Power Tool and attachment with all guards properly in
place.
4 Inspect workpiece
Remove any nails, staples and other metal parts.
5 Cutter blades
Use sharp and undamaged cutter blades only.
6 Damaged parts
Before operation, inspect the attachment, the Power Tool, the power
cable and the plug carefully for signs of damage. Have any damage
repaired by an authorized D
E
WALT repair agent before using the tool or
attachment.
7 Starting the planer
Before switching on, remove all adjustment spanners from the planer
and attachment.
8 Operating the planer and attachment
Do not overload the planer by feeding it at a too high rate. Always feed
the material against the rotational direction of the cutter block. Always
use a push stick, especially when working with smaller workpieces.
9 Stopping the planer
After switching off, the cutter block will continue to run for a few
seconds. Do not attempt to block it.
10 Maintain your attachment with care
Keep the attachment clean and in good condition for better and safer
performance. Follow the instructions for maintenance. Keep all controls
dry, clean and free from oil and grease.
11 Have your attachment repaired by an authorized D
E
WALT repair
agent
This attachment is in accordance with the relevant safety regulations.
To avoid danger, it must only be repaired by qualified technicians.
Congratulations!
You have chosen a D
E
WALT product. Years of experience, thorough
product development and innovation make D
E
WALT one of the most
reliable partners for professional users.
Table of contents
Technical data
en - 1
Manufacturer’s declaration
en - 1
Safety instructions
en - 1
Package contents
en - 2
Description
en - 2
Assembly and adjustment
en - 2
Instructions for use
en - 3
Maintenance
en - 3
Guarantee
en - 4
Technical data
DE8000
Max. surfacing width 90°
mm
82
Max. surfacing width 45°
mm
45
Max. thicknessing capacity
mm
80 x 80
Max. planing depth
mm
4.0
Thicknessing table
mm
500 x 80
Surfacing fence length
mm
350
Weight
kg
3.7
Manufacturer’s Declaration
DE8000
D
E
WALT declares that the attachment mentioned above has been
designed in compliance with 89/392/EEC.
This attachment must not be put into service until it is established that the
Power Tool to be connected to this attachment is in compliance with
89/392/EEC (identified by the CE-marking on the Power Tool).
Director Engineering and Product Development
Horst Großmann
D
E
WALT, Richard-Klinger-Straße 40,
D-65510, Idstein, Germany
