49
To fi t the wall mount to wall track, proceed as follows:
• Open the clamp jaws (14).
• Place the clamp jaw around the wall track and release the clamp to
close the clamp jaws shut on the track.
To mount the wall mount to a wall, proceed as follows:
• Hold the tool at the desired position against the wall and mark the
location of the mounting hole on the wall.
• Drill a hole at the marked location.
• Insert a corresponding plug into the hole.
• Hold the tool in front of the plug.
• Turn a screw into the mounting hole (15).
Adjusting the tool
• To initiate the leveling procedure, switch on the tool. The level and/
or plumb orientation is correctly adjusted as long as the laser beams
remain on.
• The laser beams start fl ashing to indicate that the tool has been set up
at a slope that is beyond the self-leveling range of 4°. Switch the tool
off, re-adjust the tool set-up within the self-leveling range and switch
the tool on again.
Aligning the laser line (fi g. D)
• Align the laser line of either one of the laser beams with the position
mark. Move the tool as required.
OPERATION
WARNING!
Do not place the laser in a position which may
cause anyone to intentionally or unintentionally stare into
the laser beam.
Serious eye injury may result from staring at
the beam.
E N G L I S H
Summary of Contents for DW087K
