removing the motor unit from the base. ALWAYS BE SURE THAT
THE CLAMP LEVER IS IN THE LOCKED (DOWN) POSITION
WHEN ROUTING.
The orientation of the lever can be changed if desired by loosening
the lock nut that fastens it to the router and rotating the lever to the
desired position. Retighten the lock nut.
Sub Base
Turn Off and Unplug Router
The sub base on your router has been specifically designed to permit
better visibility than conventional routers but retain the ability to use
template guides. The guide adapter, if not needed, can be easily
removed for even more visibility. To remove the adapter raise the
Clamp Lever and lift the motor assembly out of the router base. This
will enable you to reach and remove the two screws in the base
which hold the guide adapter in place, as shown in Figure 2.
When you reinstall the motor unit, be sure to align the Guide Screw
(Figure 3) with the slot in the router base.
LOCKING
LEVER
2
so marked.
•
STAY ALERT. Watch what you are doing. Use common sense.
Do not operate tool when you are tired.
•
CHECK DAMAGED PARTS. Before further use of the tool, a
guard or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that
may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in this instruction
manual. Have defective switches replaced by authorized service
center. Do not use tool if switch does not turn it on and off.
SAVE THESE INSTRUCTIONS
Motor
Your D
E
WALT tool is powered by a D
E
WALT-built motor. Be sure your
power supply agrees with the nameplate marking.
120 Volts 60Hz or “AC/DC” means your tool may be operating with
alternating or direct current.
Voltage decrease of more than 10% will cause loss of power and
overheating. All D
E
WALT tools are factory tested; if this tool does not
operate, check the power supply.
Clamp Lever
Turn Off and Unplug Router.
In order to lock the position of the router motor unit in the router base,
a lever has been provided on the side of the tool, as shown in Figure
1.
To lock the motor unit in place, push the lever all the way down; to
release the motor, raise the lever up to about a right angle to the
tool. Use this loosened position for making depth adjustments and
English
FIG. 1
FIG. 2
SUB BASE
GUIDE
ADAPTER
384404/DW628 5/2/02 1:39 PM Page 2
