DeWalt DW735-XE, Instruction Manual

5

ASSEMBLY

WARNING: 

DO NOT REMOVE GUARDS (E, Fig. 2). Serious injury could result.

WARNING: 

To reduce the risk of serious personal injury, turn tool off and disconnect 

tool from power source before making any adjustments or removing/installing 

attachments or accessories. 

An accidental start-up can cause injury.

TO ATTACH THE DEPTH ADJUSTMENT CRANK HANDLE (FIG. 3)

  1. Remove the screw located in the crank handle shaft. 
  2. Insert the crank handle (F) over the shaft. 
  3. Secure in place with the screw and T-wrench (G) provided.

E

FIG.2

D

A

B

C

G

F

FIG.3

DUST EJECTION PORTS (FIG. 4)

Your planer comes with a dust ejection port. The round port (I) as shown below is for 

use with a dust collector hose no less than 200 mm (8") in length. 

TO SET UP DUST EJECTION (FIG. 4)

  1.  Select the port (I).
  2.  Depress the lock button (K) on the chip ejection chute (H). 
  3.  Slide the notches in the dust port over the pins on the chip ejection chute.
  4.  Rotate the port until the button engages the dust ejection chute and locks in 

place.

K

H

H

C

I

FIG.4

WARNING: DO NOT OPERATE YOUR PLANER WITHOUT THE DUST EJECTION 

PORT LOCKED INTO PLACE. DO NOT INSERT ANYTHING INTO THE DUST EJECTION 

CHUTE UNLESS THE PLANER IS UNPLUGGED AND YOU ARE CLEARING A CLOG 

OR OBSTRUCTION IN THE UNIT. DO NOT GET YOUR FACE OR EYES NEAR THE 

DUST EJECTION PORT WHEN THE PLANER IS IN OPERATION. SERIOUS INJURY 

COULD RESULT.

WARNING: 

A hose no less than 200 mm (8") in length MUST be used on the dust 

ejection port in order to avoid injury.

WARNING: 

Chips are ejected at significant velocity. Keep hands and face clear of 

dust ejection port. 

TO REMOVE THE DUST EJECTION PORT

  1.  Use the T-wrench to depress the lock button on the dust chute.
  2.  Twist the port until the pins are disengaged from the notches on the port.
  3.  Pull the dust ejection port off of the dust chute.

OPERATION

WARNING: To reduce the risk of serious personal        

L

M

FIG.5

injury, turn tool off and disconnect tool from power 

source before making any adjustments or removing/

installing attachments or accessories. 

An accidental 

start-up can cause injury.