8
Guarantee
Applicable to hand held Power Tools, Lasers and Nailers.
Three Year Limited Warranty
D
E
WALT will repair, without charge, any defects due to faulty materials or
workmanship for three years from the date of purchase. Please return the complete
unit, transportation prepaid, to any D
E
WALT Service Centre, or any authorised
service station.
For warranty repair information, call (AUS) 1800 654 155 or (NZ) 09 579 7600
This warranty does not apply to
• Accessories
• Damage caused where repairs have been made or attempted by others.
• Damage due to misuse, neglect, wear and tear, alteration or modification.
This warranty gives you specific legal rights and you may have other rights under the
provisions of the Consumer Guarantee Act 1993 (New Zealand only), Trade Practices
Act 1974 and State Legislation (Australia only).
In addition to the warranty, D
E
WALT tools are covered by our:
FREE ONE YEAR SERVICE CONTRACT
D
E
WALT will also maintain the tool for free at any time during the first year of
purchase. This includes labour, parts and lubrication required to restore the product to
sound mechanical and/or electrical condition. Normal wear parts are not covered in
this service. Carbon brushes worn more then 50% will be replaced.
NOTE:
Three Year Warranty is not applicable to items deemed as consumables. Radial
arm saws are covered by a one (1) year warranty only. D
E
WALT Reserves the right to
review its warranty policy prior to launch of any new business development products.
30 DAY NO SATISFACTION GUARANTEE
If you are dissatisfied with any D
E
WALT power tool, laser or nailer, for any reason,
simply return it to the point of purchase with your sales receipt within 30 days for a
replacement unit or a full refund.
MAINTENANCE
WARNING: Shock Hazard.
To reduce the risk of serious personal injury, turn tool
off and disconnect tool from power source before making any adjustments or
removing/installing attachments or accessories.
Cleaning
WARNING:
Blow dirt and dust out of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this. Exterior plastic parts may be cleaned with a damp
cloth and mild detergent. Although these parts are highly solvent resistant, NEVER use
solvents.
Lubrication
Your tool was properly lubricated before leaving the factory. In from two to six
months, depending upon use, take or send your tool to an authorized service
center for a complete cleaning, inspection and lubrication. Tools used constantly
on production jobs will need relubrication more often. Also, tools “out of service” for
long periods should be relubricated before being put back to work.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING:
Since accessories, other than those offered by D
E
WALT, have not been
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
E
WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory,
please contact D
E
WALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138
Australia or call 1800 654 155 or (NZ) 09 579 7600.
Summary of Contents for DW849-XE
Page 1: ...DW849 XE POLISHER INSTRUCTION MANUAL ...
Page 2: ......
