ENGLISH
29
Indexing the Chisel Position (fig. 2)
The chisel can be indexed and locked into 52
different positions.
1. Rotate the mode selector switch (d) until it
points to the “bit rotation” position.
2. Rotate the chisel in the desired position.
3. Set the mode selector switch (d) to the
“hammering only” position.
4. Twist the chisel until it locks in position.
Inserting and Removing SDS Plus
®
Accessories (fig. 3)
This tool uses SDS Plus
®
accessories (refer to the
inset in fig. 3 for a cross-section of an SDS Plus
®
bit shank). We recommend to use professional
accessories only.
1. Clean and grease the bit shank.
2. Insert the bit shank into the tool holder (f).
3. Push the bit down and turn it slightly until it fits
into the slots.
4. Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
5. To remove a bit, pull back the tool holder
locking sleeve (j) and pull out the bit.
WARNING:
Always wear gloves when
you change accessories. The exposed
metal parts on the tool and accessory
may become extremly hot during
operation.
Fitting the Side Handle (fig. 4)
The side handle (h) can be fitted to suit both RH-
and LH-users.
WARNING:
Do not use the tool without
the side handle properly assembled.
1. Loosen the side handle.
2.
For RH-users:
slide the side handle clamp
over the collar behind the tool holder, handle at
the left.
For LH-users:
slide the side handle clamp over
the collar behind the tool holder, handle at the
right.
3. Rotate the side handle to the desired position
and tighten the handle.
Forward/reverse Slider (fig. 5)
1. Push the forward/reverse slider (c) to the
RH-side for forward (RH) rotation. See arrows
on tool.
2. Push the forward/reverse slider (c) to the
LH-side for reverse (LH) rotation.
WARNING:
Always wait until the motor
has come to a complete standstill
before changing the direction of rotation.
Fitting the Chuck Adapter and Chuck
1. Screw the chuck onto the threaded end of the
chuck adapter.
2. Insert the connected chuck and adapter in the
tool as though it were a standard SDS Plus
®
bit.
3. To remove the chuck, proceed as for removing
a standard SDS Plus
®
bit.
WARNING:
Never use standard chucks
in the hammerdrilling mode.
Replacing the Dust Cover (fig. 3)
The dust cover (g) prevents dust ingress into the
mechanism. Replace a worn dust cover immediately.
1. Pull back the tool holder locking sleeve (j) and
pull the dust cover (g) off.
2. Fit the new dust cover.
3. Release the tool holder locking sleeve.
OPERATION
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Instructions for Use
WARNING:
•
Always observe the safety instructions
and applicable regulations.
•
Be aware of the location of pipework
and wiring.
•
Apply only a gentle pressure to
the tool (approx. 5 kg). Excessive
force does not speed up drilling but
decreases tool performance and may
shorten tool life.
•
Do not drill or drive too deep to
prevent damage to the dust cover.
Summary of Contents for DWEN102
Page 1: ...DWEN102 www eu ...
Page 3: ...1 Figure 1 Figure 2 a d f g h b c e k i d e ...
Page 4: ...2 Figure 3 Figure 5 Figure 4 Figure 6 f g j h c ...
Page 135: ...133 ...
