ENGLISH
38
a.
The ring on the threaded clamp nut (h) must
face towards the disc when fitting a grinding
disc (fig. 5A);
b.
The ring on the threaded clamp nut (h) must
face away from the disc when fitting a cutting
disc (fig. 5B).
5. Press the spindle lock button (c) and rotate the
spindle (o) until it locks in position.
6. Tighten the threaded clamp nut (h) with the two-
pin spanner supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the threaded clamp
nut (h) with the two-pin spanner.
Fitting and Removing a Backing Pad/
Sanding Sheet (fi g. 1, 5)
1. Place the tool on a table, guard up.
2. Remove the backing flange (i).
3. Place the rubber backing pad correctly onto the
spindle (o).
4. Place the sanding sheet on the rubber backing
pad.
5. Screw the threaded clamp nut (h) onto the
spindle (o). The ring on the threaded clamp nut
(h) must face towards the rubber backing pad
(Fig. 5A).
6. Press the spindle lock button (c) and rotate the
spindle (o) until it locks in position.
7. Tighten the threaded clamp nut (h) with the two-
pin spanner.
8. Release the spindle lock
9. To remove the rubber backing pad, loosen
the threaded clamp nut (h) with the two-pin
spanner.
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle
without the use of the spacer and threaded flange.
Prior to Operation
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer flange are mounted
correctly.
• Make sure the disc or wheel rotates in the
direction of the arrows on the accessory and the
tool.
OPERATION
Instructions for Use
WARNING:
Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
WARNING:
Always wear regular
working gloves while operating this tool.
WARNING:
The gear case becomes
very hot during use.
WARNING:
•
Ensure all materials to be ground or
cut are secured in place.
•
Apply only a gentle pressure to the
tool. Do not exert side pressure on the
disc.
•
Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
•
Install the guard and appropriate disc
or wheel. Do not use excessively worn
discs or wheels.
•
Be sure the inner and outer flange are
mounted correctly.
•
Make sure the disc or wheel rotates
in the direction of the arrows on the
accessory and the tool.
Proper Hand Position (fi g. 6)
WARNING:
To reduce the risk of
serious personal injury,
ALWAYS
use
proper hand position as shown.
WARNING:
To reduce the risk of
serious personal injury,
ALWAYS
hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the side
handle (e), with the other hand on the main handle (f)
of the tool, as shown.
Summary of Contents for DWEN202
