26
ENGLISH
DWV9401-XJ
Paper bag
DWV9402-XJ
Fleece bag
DWV9500-XJ
Vac Rack
D
E
WALT AirLock System
DWV9000
Twist-Lock
connection
DWV9110
29-35 mm tapered
rubber adapter
DWV9120
35-38 mm stepped
rubber adapter
DWV9130
35 mm OD adapter
DWV9150
35 mm OD angle
adapter
VAC RACK DWV9500 INSTALLATION (FIG. 9)
NOTE:
The DWV900LT comes with DWV9500 vac
rack attachment already installed,
1. Remove the 4 carry handle screws using a T-25
star bit and remove the carry handle.
2. Install the vac rack reusing the carry handle
screws. Put them back in their original holes
and tighten.)
3. Use the 2 screws (v) provided by placing them
in the rear holes of the vac rack. Push down
and turn each screw to break through the
material and into the hidden screw boss below.
Tighten.
CAUTION:
Do not exceed 9 kg (20 lb)
in each 14 liter storage unit, maximum
2 storage units per dust extractor. Do
not exceed 18 kg (40 lb) in a 28 liter
storage unit, 1 storage unit per dust
extractor. Exceeding the recommended
height and/or weight could result in an
unstable dust extractor would could
cause injury or damage.
NOTICE:
Do not remove dust extractor
head from tank with T-stack storage
units attached. Doing so could result in
damage to the dust extractor filter.
SECURING THE POWER CORD TO THE HOSE (FIG. 1)
The power cord (b) can be secured to the suction
hose (g) using the D279058CL hose clip (available
from your local D
E
WALT supplier).
Consult your dealer for further information on the
appropriate accessories.
NOTE:
Use care to not damage filter material.
3. Place the vacuum head (d) onto the container
and secure it by closing the canister latches (e).
Lubrication
Your appliance requires no additional lubrication.
Cleaning
WARNING:
Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the appliance. These
chemicals may weaken the materials
used in these parts. Never let any liquid
get inside the machine; never immerse
any part of the appliance into a liquid.
1. Vacuum the outside of the dust extractor. For
further cleaning use a cloth dampened only with
water and mild soap if necessary.
2. After use dispose of cloth in an appropriate
container.
Storage (fi g. 1)
1. Empty the canister, refer to
To Empty Canister
under
Operation
.
2. Clean the vacuum inside and outside. Refer to
Cleaning.
3. Clean or replace filter, refer to
Filter
.
4. Store the suction hose and the power cord (b)
as shown in the illustration. Place the unit in a
dry room and secure it from unauthorized use.
Optional Accessories
WARNING:
Since accessories, other
than those offered by D
E
WALT, have
not been tested with this product, use
of such accessories with this appliance
could be hazardous. To reduce the risk
of injury, only D
E
WALT recommended
accessories should be used with this
product.
ACCESSORIES
DWV9340-XJ
Filter
DWV9315-XJ
Crush-proof hose
