20
&OHMJTI
5SPVCMFTIPPUJOH(VJEF
5IJT TFDUJPO QSPWJEFT B MJTU PG UIF NPSF GSFRVFOUMZ FODPVOUFSFE NBMGVODUJPOT UIFJS DBVTFT BOE DPSSFDUJWF BDUJPOT 5IF
PQFSBUPSPSNBJOUFOBODFQFSTPOOFMDBOQFSGPSNTPNFDPSSFDUJWFBDUJPOTBOEPUIFSTNBZSFRVJSFUIFBTTJTUBODFPGBRVBMJGJFE'/"UFDIOJDJBO
or your dealer.
Problem
Code
Engine will not start ........................................................................................................1, 2, 3, 4, 5, 6, 7, 8, 36
(refer to the engine's instruction manual for further engine troubleshooting)
No or low pressure (initial use) ........................................................................................9, 10, 11, 12, 13, 14, 15, 16
Will not draw chemicals ..................................................................................................16, 17, 18, 19, 20, 21
No or low pressure (after period of normal use) ..............................................................22, 23, 24
Water leaking at gun/spray wand connection .................................................................25, 26
Water leaking at pump....................................................................................................25, 26, 27, 28
Oil leaking at pump .........................................................................................................29, 30, 31, 32, 33, 34, 35
Pump Pulsates................................................................................................................12
5SPVCMFTIPPUJOH$PEFT
CODE
POSSIBLE CAUSE
POSSIBLE SOLUTION
1
No fuel.
Add fuel.
2
Low oil.
"EESFRVJSFEBNPVOUPGPJM
3
Pressure builds up after two pulls on the recoil starter or after
initial use.
4RVFF[FHVOUSJHHFSUPSFMJFWFQSFTTVSF
4
Choke lever in the NO CHOKE position.
Move choke to the CHOKE position.
5
Spark plug wire not attached.
Attach spark plug wire.
6
Engine ON/OFF switch in OFF position.
Place engine ON/OFF switch in ON position.
7
Choke lever in the CHOKE position on a
hot
engine or an
engine that has been exposed to thermal heat for a long
period of time.
Move choke to the NO CHOKE position.
