12
ENGLISH
Assembling the Sprayer
1. Install the wand (C) onto the shut-off assembly
(B) and tighten the nut (1) on the wand (C) to
secure together.
Fig. 4
C
1
B
Attaching a Nozzle
Attach your selected nozzle (J – O) onto the end of the
wand (C) using a flat seal (E) if required, and tighten
securely using the cap nut (D).
Fig. 5
C
E
K
D
C
O
Harness Installation
1. For each side of the harness (G), remove the
small plastic clips (1) from the two shoulder strap
loops and thread each loop through the slots at
the top of the sprayer handle.
2. Replace the clips (1) through the loops and pull
the strap securing the two harness (G) straps in
place.
Fig. 6
1
G
3. Insert the strap into the “back” cutout of the
lower base below the steel harness rod. Pull
excess length through to allow for step 2.
4. Loop excess strap below and back through the
“bottom” cutout. Be sure that the strap loops
around below the harness rod.
5. As the strap is pushed, it will follow the curved
surface of the plastic lower base, and come back
outward from the “back” cutout.
6. Pull excess material through to loop back
through first section of buckle.
NOTE:
If the strap comes right out of the lower base
when pulling through the buckle (or prior), this shows
that the strap was not properly looped around the
harness rod, and steps 3-6 will need to be repeated.
7. Loop through second portion of buckle above
lower strap section, and adjust accordingly.
8. Harness in assembled position as shown in Fig 7.
Fig. 7
2
3
G
9. Loop the strap through the first section of
the buckle (2). Then loop the strap through
the other section of the buckle (2) to tighten.
Adjust the shoulder pads and strap lengths for a
comfortable fit.
Fig. 8
2
3
G
