58
EnGLIsh
Protecting the Environment
w
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at
www.2helpU.com
.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce
sufficient power on jobs which were easily done before. At the end
of its technical life, discard it with due care for our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Tool Connect™ Chip (Fig. N)
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories.
An accidental
start-up can cause injury.
Your tool is Tool Connect™ Chip ready and has a location for
installation of a Tool Connect™ Chip.
Tool Connect™ Chip is an optional application for your
smart device (such as a smart phone or tablet) that connects
the device to utilize the mobile application for inventory
management functions.
Refer to
Tool Connect
™
Chip Instruction Sheet
for
more information.
Installing the Tool Connect™ Chip
1. Remove the retaining screws
22
that hold the Tool
Connect™ Chip protective cover
23
into the tool.
2. Remove the protective cover and insert the Tool Connect™
Chip into the empty pocket
24
.
3. Ensure that the Tool Connect™ Chip is flush with the
housing. Secure it with the retaining screws and tighten
the screws.
4. Refer to
Tool Connect
™
Chip Instruction Sheet
for
further instructions.
Guard Types for DCG440
Type B
(Shallow, Grinding)
Type B
(Deep, Grinding)
Type A
(Closed cut off)
Type E
(Diamond surface grinding wheel guard))
Type A (Type 41) guards are intended for use with Type 41 (1A) cutting wheels and Type 42 (27A) wheels marked for cutting only.
Grinding with wheels other than Type 27 and Type 29 require different accessory guards. Always use the smallest proper guard
possible that does not contact the accessory.
nOTE:
Type A (cut‑off) and Type B (grinding) wheel guards where previously referred to as Type 1 and Type 27 wheel guards.
