DeWalt XR LI-ION DCL023-XE, Instruction Manual

7

FIG 2.

A

B

C

INTENDED USE

This flashlight is designed for professional applications.

DO NOT

 use under wet conditions or in presence of flammable liquids or gases.

This flashlight is a professional tool. 

DO NOT

 let children come into contact with the 

tool. Supervision is required when inexperienced operators use this tool.

OPERATION

WARNING: To reduce the risk of serious personal injury, turn the tool off and 

disconnect the battery pack before making any adjustments or removing/installing 

attachments or accessories. 

An accidental start-up can cause injury.

Installing and Removing the Battery Pack (Fig. 3)

NOTE:

 For best results, make sure your battery pack is fully charged. 

FIG. 3

B

C

To install the battery pack (B) into the tool handle, align the battery pack with the 

rails inside the tool’s handle and slide it into the handle until the battery pack is firmly 

seated in the tool and ensure that it does not disengage.

To remove the battery pack from the tool, press the release button (C) and firmly pull 

the battery pack out of the tool handle. Insert it into the charger as described in the 

charger section of this manual.

Switch (Fig. 1)

To turn the light on, press the switch (A). To turn it off, press the switch again.

Battery Indicator

As the battery nears a fully discharged state, the flashlight will blink twice and then 

the brightness of the light will drop below the normal level. This cycle will repeat for a 

period of up to 15 minutes until the battery is fully discharged.

MAINTENANCE

WARNING: To reduce the risk of serious personal injury, turn the tool off and 

disconnect the battery pack before making any adjustments or removing/installing 

attachments or accessories. 

An accidental start-up can cause injury.

Cleaning

WARNING:

 Blow dirt and dust out of all air vents with clean, dry air at least once 

a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye 

protection when performing this. 

WARNING:

 Never use solvents or other harsh chemicals for cleaning the 

non-metallic parts of the tool. These chemicals may weaken the plastic materials 

used in these parts. Use a cloth dampened only with water and mild soap. Never let 

any liquid get inside the tool; never immerse any part of the tool into a liquid.

CHARGER CLEANING INSTRUCTIONS

WARNING: 

Shock hazard. Disconnect the charger from the AC outlet before 

cleaning. Dirt and grease may be removed from the exterior of the charger using a 

cloth or soft non-metallic brush. Do not use water or any cleaning solutions.

Repairs

This charger and battery pack are not serviceable. Servicing at an authorized service 

centre is required to avoid damage to static sensitive internal components.

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment 

(including brush inspection and replacement) should be performed by certified 

service centers or other qualified service organizations, always using identical 

replacement parts.