DeWalt XR-LI-ION DCV582-XE, Instruction Manual

10

Cleaning

WARNING:

 Blow dirt and dust out of all air vents with clean, dry air at least once 

a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye 

protection when performing this. 

WARNING:

 Never use solvents or other harsh chemicals for cleaning the 

non-metallic parts of the tool. These chemicals may weaken the plastic materials 

used in these parts. Use a cloth dampened only with water and mild soap. Never let 

any liquid get inside the tool; never immerse any part of the tool into a liquid.

CHARGER CLEANING INSTRUCTIONS

WARNING: 

Shock hazard. Disconnect the charger from the AC outlet before 

cleaning. Dirt and grease may be removed from the exterior of the charger using a 

cloth or soft non-metallic brush. Do not use water or any cleaning solutions.

Repairs

This charger and battery pack are not serviceable. Servicing at an authorized service 

centre is required to avoid damage to static sensitive internal components.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment 

(including brush inspection and replacement) should be performed by certified 

service centers or other qualified service organizations, always using identical 

replacement parts.

Accessories (Fig. 7)

WARNING: 

Since accessories, other than those offered by D

E

WALT, have not been 

tested with this product, use of such accessories with this tool could be hazardous. 

To reduce the risk of injury, only D

E

WALT recommended accessories should be used 

with this product. 
The DCV582 includes a 1-1/4” hose, crevice tool (stored in the handle) and wide 

nozzle.
The replacement filter (DCV5801H-XJ) and air-lock adapter (DWV9000-XJ) are 

available as accessories at additional cost.

Cord, Hose and Accessory Storage (Fig. 2)

When the vacuum is not in use, the power cord should be secured around the 
vacuum handle underneath the cord wrap (J). The vacuum hose can be wrapped 
around appliance, underneath the battery interface, and secured with the hose clip (G) 
also located at the back of the vacuum. The two accessories (crevice tool and wide 
nozzle) can be stored on board the vacuum as well.
Recommended accessories for use with your tool are available at extra cost from 

your local service center. If you need any assistance in locating any accessory, please 

contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call 

1800 338 002 or (NZ) 0800 339 258.