SyStem SetuP
20
Installing a TRION module
5
1
3
2
5
4
Fig. 4: Installing a TRION module
1.
DEWE3 chassis
2.
TRION series module
3.
Injector/ejector module
4.
Module guides
5.
Mounting screws
In order to install a TRION module into a chassis proceed as follows:
1.
Take proper ESD precautions to avoid any damage to the unit.
2.
Power off and unplug all connected cables including sensors from the DEWE3 chassis and TRION/TRION3 series
modules.
3.
Identify a supported TRION/TRION3 peripheral slot.
Some modules require a TRION STAR-slot.
4.
Remove the filler panel of an unused TRION/TRION3 peripheral or STAR-slot.
5.
Place the module edges of the TRION/TRION3 module into the module guide at the top and bottom of the chassis.
6.
Insert the TRION/TRION3 module to the rear of the chassis until a resistance appears.
7.
Pull up on the injector/ejector handle to latch the device.
8.
Secure the installed TRION front panel to the chassis by using the mounting screws.
The TRION/TRION3 module is now installed into a DEWE3 chassis.
NOTICE
Unused TRION slots must always be covered. Make sure to reinstall the filler panels to unused TRION
slots to guarantee proper cooling of the installed modules.
The warranty is void if the modules overheat due to missing filler panels.
Summary of Contents for DEWE3-A4
Page 6: ...TABLE OF CONTENTS 6 Notes ...
Page 29: ...Certificate of conformity 30 Notes ...
Page 31: ...Glossary 32 ...