Page 7 of 12
Dewhot
| Gas geyser manual
Dewhot
| Gas geyser manual
Installation instructions
Mounting the Gas Geyser body
Drill 4 x 8mm holes into the wall matching
the holes on the back of the gas geyser.
Use 6mm expansion bolts.
Hang the gas geyser, and then attach it
with the expansion bolt to the hole of
lower bracket.
Cold Water Supply Pipe
The cold water inlet joint is a standard half
inch (15mm) male plumbing fitting.
The water inlet pipe should be connected
using a rigid water pipe.
The inner diameter of the inlet pipe
(including the valve) shouldn’t be less than
8mm.
Check that the inlet sieve is secure before
installing the cold water pipe. This sieve
ensures that any particles in the new pipe
do not enter the gas geyser.
Hot Water Supply Pipe
The hot water outlet joint is a standard half
inch (15mm) male plumbing fitting
The hot water outlet pipe should be
connected using a rigid water pipe.
The inner diameter of the hot water outlet
pipe (including the valve) shouldn’t be less
than 8mm.
After installation
Open the cold water valve to the
maximum to test the water flow and check
whether there are any leaks.
Gas Supply Pipe
The gas inlet joint is a standard half inch
(15mm) male plumbing fittings..
The gas line should be connected using
an approved method of piping and fitting
according SANS 10087-1
After the gas inlet joint is connected, open
the gas supply valve, and check whether
there is a gas leak at the joint by using
soapy water or a gas manometer.
The gas geyser should be used with a low
pressure regulator of 2,8 KPA.
Summary of Contents for LPDH 5
Page 1: ...5L Flueless Low Pressure...
