Page 8 of 12
Dewhot | Gas geyser manual
1. Open the battery box and insert two ‘D’
Cell sized batteries
2. Open both the cold and hot water
valve. Close the water Inlet valve after
you make sure the cold water is flowing
out through the water outlet and the
ignition pins fire up.
3. Open the gas supply
4. Open the water inlet valve and
the geyser will ignite immediately.
Sometimes because there is air in the
gas pipe, it may not ignite the first time,
so, try two or three times.
5. By closing the water inlet or outlet
valve the gas heater will stop working.
If needed again, just re-open the water
inlet valve or water outlet valve. Please
note that the temperature of hot water
flowing out is higher so wait for the
temperature to stabilise.
6. This gas geyser may only be used for
short delivery periods and may not be
used for the purpose of supplying hot
water to a bath or washing machine.
7. This gas geyser may only be installed
in a room if the room meets the
appropriate ventilation requirements
(refer to SANS 10087-1)
8. This gas geyser shall not be
connected to a flue.
Operating instructions
Summary of Contents for LPDH 5
Page 1: ...5L Flueless Low Pressure...
