16
will repeat a total of 10 times, at which time the wrinkle free cycle stops. The cylinder will not rotate
again until a new dry cycle is started.
During the wrinkle free cycle the gas valve will not be operated and there will be no heat applied to
the load. The word “donE” will also continue to flash and do so even after the wrinkle free cycle is
finished. When the dryer loading door is opened, or the
STOP
touch pad key is pressed, the word
“donE” will change to the word “LOAd” on the dryer controller display. The dryer will then be ready
for another dry cycle.
During the dry cycle, either pressing the STOP touch pad key on the dryer controller or opening the
dryer loading door, will stop the dry cycle and not clear it. If you press the STOP touch pad key on
the controller and then open the dryer loading door the dry cycle will not be cleared. However, if you
open (or open and close) the dryer loading door and then press the STOP touch pad key on the dryer
controller, the present dry cycle will be cleared and the word “LOAd” will appear on the dryer
controller display.
There are two jumpers and one push button on the component side of the dryer controller printed
circuit board.
The jumper located at the back right side of the each circuit board controls whether the controller
display shows and operates in the Fahrenheit or Celsius mode. This jumper is labeled as TEMP
SELECT and has three pins. The back and middle pins are for Celsius and the front and middle pins
are for Fahrenheit, which is indicated by the letter C for Celsius and the letter F for Fahrenheit.
The other jumper, located at the back middle side of each circuit board controls, is used for choosing
either a reversing or non-reversing type of dryer. This jumper is labeled as REV and NON-REV.
This jumper must be in the non-reversing position, which are the front and middle pins. If the jumper
is in the reversing position, the heating part of the dry cycle will not operate properly. The dryer will
not reverse direction either.
The push button, which is located at the middle center of each circuit board controls, is used to reset
all five of the dry cycles to the factory default settings. It is labeled as DEFAULT SETTINGS. Even
the dry cycles that have been modified using the permanent programming procedure will be changed
back to the factory default settings when using this push button. This push button must be pressed
and held for at least three seconds with power applied to the dryer controller circuit board.
If changing a jumper, remove power before moving jumper and then move jumper. Before restoring
power, press and hold the DEFAULT SETTINGS pushbutton. Then, restore power and release the
DEFAULT SETTINGS pushbutton after three seconds of restoring power.
TEMPORARY DRYER CONTROLLER PROGRAMMING
Summary of Contents for DDAD30HC-59 Series Dryers
Page 3: ...3 Figure 1 30 Stack Dryer Dimensions inches mm ...
Page 11: ...11 ...
