Dexter Laundry DDAD30HC-59 Series Dryers, Operator'S Manual

21 

flash. If you press and hold either arrow key down, you will increment (

UP

 arrow) or decrement 

(

DOWN

 arrow) your way through the available drying temperatures (105

º

 Fahrenheit or 40

º

 Celsius, 

up to 195

º

 Fahrenheit or 91

º

 Celsius).  If you do not want to change the drying temperature, do not 

press the arrow keys.  Go to the next step. 

 
9)

Press and release the 

SELECT/ENTER

 key.  Once this key is pressed and released, the temperature 

L.E.D. will switch off, the dry cycle L.E.D. and programming L.E.D. will remain on, and the cool 
down L.E.D. will illuminate.  The cool down time will also be shown on the 4-digit numeric display. 

 
10)

Press and release the 

UP

 or 

DOWN

 arrow keys to change the cool down time. Once either of the 

arrow keys is pressed, the cool down L.E.D. and the cool down time on the 4-digit numeric display 
will flash.  If you press and hold either arrow key down, you will increment (

UP

 arrow) or decrement 

(

DOWN

 arrow) through the cool down times available (2 through 60 minutes).  To not change the 

cool down time, do not press the arrow keys.  Go to the next step. 

 
11)

Press and release the 

SELECT/ENTER

 key.  Once this key is pressed and released, the cool down 

L.E.D. will switch off, the dry cycle L.E.D. and programming L.E.D. will remain on, and the 4-digit 
numeric display will change to “Prog”. 

 
12)

Press and release the 

STOP

 key to save the cycle program and escape the programming mode.  If you 

want to change the same dry cycle program again, press the 

SELECT/ENTER

 key and continue at 

step 6 of this procedure.  If you want to modify another dry cycle program, go to step 4 of this 
procedure and continue. 

 
13)

If you pressed the 

STOP

 key to escape the programming mode, you may now start the dry cycle by 

pressing the 

START

 key. 

PERMANENT DRYER CONTROLLER PROGRAMMING EXAMPLE 

 
REQUIREMENTS:   Dry a load with 50 minutes of actual heat at 195

º

 F and three minutes of cool down. 

 
    The following procedure will show you how to permanently modify the existing dry cycle 1 program 
for one cycle of drying.  It is based on the assumption that the factory defaults have not been permanently 
changed.  If they have been changed, the steps of this procedure will be the same, but the values that are 
displayed will be different.  The amount of times that the dryer controller touch pad UP or DOWN keys 
must be pressed and released may also be different. 
 
    If you want the change to be temporary (for only one dry cycle), go to the “TEMPORARY DRYER 
CONTROLLER PROGRAMMING” section of this manual. 

PROCEDURE 

 
1)

After the load has been placed in the dryer, press and release the 

UP

 or 

DOWN

 touch pad key on the 

dryer controller until the L.E.D. for dry cycle 1 is illuminated.