-13-
DSC Wiring Harness
The DSC wire harness has five wires requiring electrical
connection and one wire for the status LED light. The function of
each of these wires is outlined in the table below:
DSC
Wires
Trailer Wire Function
Wire Gauge
Required
Purple Wire Left side electric brake
output (all left side
brakes)
14 Gage Minimum
Pink Wire
Right side electric brake
output (all right side
brakes)
14 Gage Minimum
White Wire
Trailer battery/frame
ground point
14 Gage Minimum
Blue Wire
Electric brake controller
signal from tow vehicle
14 Gage Minimum
Black Wire
12VDC from tow vehicle
trailer harness
14 Gage Minimum
Gray Wire
10' wire with a two pin
connector on the end that
plugs into the LED status
light
Included in kit
The 14 gauge wires of the DSC wiring harness are approximately
12" long to allow for flexibility when mounting the unit. Extensions
will be required to connect unit to the trailer’s electrical wiring.
When making connections to the trailer’s wiring harness, the
desired termination is a solder joint. If the connection is not
soldered, use the appropriate size and type of “crimp-type”
weather sealed heat-shrink connectors, using the manufacturer’s
recommended crimping tools in accordance with their crimping
instructions.
Once the 14 gauge wires are connected, route the Status Light
wire to a location on the front of the trailer and mount the Status
Light Module onto a flat surface using two (2) #6 self-tapping
screws. Select a location that makes it easy to see the Status
Light when looking at the front of the trailer.
Dexter Sway Control Wiring
Summary of Contents for DSC
Page 28: ... 27 Notes ...