Dexter Power 3276000254652, Legal And Safety Instructions

21

EN

1. SAFETY INSTRUCTIONS

e) Do not attach a saw chain woodcarving blade or toothed saw blade.

 Such blades create 

     frequent kickback and loss of control.

Operations.Additional safety instructions for polishing operations
Safety Warnings Specific for Polishing
a) Do not allow any loose portion of the polishing bonnet or its attachment strings to spin 
     freely. Tuck away or trim any loose attachment strings. 

Loose and spinning attachment strings 

     can entangle your fingers or snag on the workpiece.

EXTRA SAFETY REGULATIONS CONCERNING POLISHER

1.Wear ear protectors with this polisher. Exposure to noise can cause hearing loss.
2. Check that speed marked on the label is equal to or greater than the rated speed of the polisher.
3. Inspect the sponge pad before use. Do not use chipped, cracked or otherwise defective products.
4. Ensure that the bonnets are fitted in accordance with the manufacturer’s instructions.
5. Ensure that the bonnet is correctly mounted and tightened before use and run the tool at no-load for 
     30 seconds in a safe position. Stop immediately if there is considerable vibration or if other defects 
     are detected. If this condition occurs, check the machine to determine the cause.
6. Ensure that sparks resulting from use do not create a hazard e.g. do not hit persons, or ignite 
     flammable substances.
7. For cleaning, personal protective equipment such as gloves and apron should be worn.
8. The wheel continues to rotate after the tool is switched off. And it will stop soon.
9. Do not use the polisher as a fixed tool.

The tool must be used only for its prescribed purpose. Any use other than those mentioned in this Manual 
will be considered a case of misuse. The user and not the manufacturer shall be liable for any damage or 
injury resulting from such cases of misuse. To use this tool properly, you must observe the safety 
regulations, the assembly instructions and the operating instructions to be found in this Manual. All 
persons who use and service the machine have to be acquainted with this Manual and must be informed 
about its potential hazards. Children and frail people must not use this tool. Children should be 
supervised at all times if they are in the area in which the tool is being used. It is also imperative that you 
observe the accident prevention regulations in force in your area. The same applies for general rules of 
occupational health and safety. The manufacturer shall not be liable for any changes made to the tool 
nor for any damage resulting from such changes. Even when the tool is used as prescribed it is not 
possible to eliminate all residual risk design:
Damage to the lungs if an effective dust mask is not worn.
Damage to hearing if effective hearing protection is not worn.