AME2 M3/NM3 LE3/LS3 Installation Leaflet
DIL-0300-0066
Revision - B
25/04/2022
Voltage: 220-240V / 50-60Hz
LED Power: 4.5W (1W for NM3)
Output: 460 lm (160 lm for NM3)
Battery: Li-FeP04 18650 3.2V 1500mAh
Operating Temperature: 0°C - 40°C
WARNING - THIS LUMINAIRE MUST BE EARTHED
This luminaire has been tested and is manufactured to comply with BS EN
60598 : specification for general requirements and tests. It should be installed by
a suitably qualified person in accordance with IEE.
CAUTION
: there is a potential risk of electric shock from the LED boards when
the product is operational with the cover removed.
NOTE
: INSTALLATION AND OPERATION OF THE LUMINAIRE BEYOND ITS
SCOPE OF SUPPLY WILL INVALIDATE THE WARRANTY.
1.
Remove the diffuser by loosening the two screws.
2.
Release the tray by pushing the tabs outwards. Pull
the tray down, away from the body.
3.
Drill out the cable entry point on the rear of the
housing. Ensure a suitable cable gland is used in order
to maintain the IP65 rating.
4.
Drill through the two fixing points on the back face.
Ensure the fixing points are adequately sealed in
order to maintain the IP65 rating. Secure the
luminaire with two screws.
5.
Pass the cable through the cable gland, and wire
directly into the terminal block. Proceed to connect
the battery.
6.
Refit the diffuser to the body, and secure in place
using the two screws.
BEFORE installation, the electrical supply and battery pack MUST be disconnected.
- M3
- NM3
