Fig. 3.1
Fig. 3.4
Fig. 3.5
Fig. 3.2
Fig. 3.3
Step 1: Open the device
Instructions:
1. Unscrew the two back screws using a star (Phillips)
screwdriver.
2.Remove the back cover from the end where the
screws are located and gently lift it up. If necessary, use a
screwdriver to carefully pry open the enclosure once the
screws have been removed.
Step 2: Plug in the power connector
Instructions:
1. Take care to maintain the original orientation of the back
cover to the enclosure.
2. Plug the 2-pin power plug into the board connector. The
green LED on the board will flash temporarily once power has
been successfully connected.
3. Device Preparation
4
