44
2
Hardware Installation
S/PDIF Connector
The S/PDIF connector (SPDIF1) is used to connect external S/PDIF
ports. Your S/PDIF por ts may come mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then insert the audio cable connector to
SPDIF1. Make sure pin 1 of the audio cable connector is aligned
with pin 1 of SPDIF1.
W
1
5
+5V
Key
SPDIF out
GND
SPDIF in
Summary of Contents for G7V600-B
Page 1: ...G7V600 B System Board User s Manual 935 G7V601 000G A90300603 ...
Page 15: ...15 2 Hardware Installation System Board Layout Chapter 2 Hardware Installation ...
Page 109: ...109 4 Supported Software 5 Click Finish to exit the wizard ...
Page 111: ...111 4 Supported Software 3 Click Finish Reboot the system for DirectX to take effect ...