6
RAID
159
7. This time, select “ALI ATA/RAID Controller”. Press <Enter> to
install the driver.
8. If you need to install other devices, please do so at this time
otherwise please proceed to the next step.
9. Follow the prompts on the screen to complete installation.
10. After installing the operating system, if in any case necessary,
create the hard drives' partition.
Installing the Sil 3114 RAID Driver While in the Process of
Installing Windows
®
XP or Windows
®
2000
1. Start Windows Setup by booting from the installation CD.
2. Press <F6> when prompted at the beginning of Windows setup.
3. Press <S> to select “Specify Additional Device”.
4. At this point you will be prompted to inser t a floppy disk
containing the RAID driver. Insert the provided RAID driver
diskette.
5. Locate for the drive where you inserted the diskette then select
the Silicon Image controller. Press <Enter> to install the driver.
6. If you need to install other devices, please do so at this time
otherwise please proceed to the next step.
7. Follow the prompts on the screen to complete installation.
Installing the Sil 3114 RAID Driver on Existing Windows
®
XP or
Windows
®
2000
1. Insert the provided CD into a CD-ROM drive.
2. On the left side of the autorun screen, click the “TOOLS” icon.
3. Click “Silicon Image RAID Drivers”. A “readme” screen which
contains the RAID drivers installation instructions will appear.
4. Follow the installation instructions to complete installtion.
5. Reboot the system for the driver to take effect.
Summary of Contents for LanParty UT CFX3200-DR
