40
2
Hardware Installation
S/PDIF Connector
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF
port may be mounted on a card-edge bracket. Install the card-edge bracket to
an available slot at the rear of the system chassis then connect the audio cable
to the S/PDIF connector. Make sure pin 1 of the audio cable is aligned with pin 1
of the S/PDIF connector.
5
1
+5V
Key
SPDIF out
Ground
SPDIF in
Summary of Contents for LR102 SERIES
Page 1: ...LR102 SERIES System Board User s Manual A17910140 ...
Page 101: ...101 4 Supported Software 5 After completing instal lation click Close to exit setup ...
Page 112: ...112 4 Supported Software 4 You can now access the utility ...
Page 118: ...118 4 Supported Software 3 Click Finish to exit installa tion ...