19
Chapter 2
HARDWARE INSTALLATION
User's Manual |
SO630
Please follow the steps below to install the card into the socket.
Step 2:
Press the end of the card far
from the socket down until
against the stand-off.
Step 3:
Screw tight the card onto the
stand-off with a screw driver
and a stand-off screw until
the gap between the card and
the stand-off closes up. The
card should be lying parallel to
the board when it’s correctly
mounted.
Step 1:
Insert the card into the socket
at an angle while making sure
the notch and key are perfectly
aligned.
M.2 Module
M.2 Socket
Key
Stand-off
Notch
X
Internal I/O Connectors
X
Expansion Slots
1
1
2
8
7
1
1
1
1
1
EPYC
AMD
TM
1
2
12
1
10
11
20
1
1
2
13
14
1
The lithium ion battery addendum supplies power to the real-time clock and CMOS memory
as an auxiliary source of power when the main power is shut off. Insert a coin cell battery into
the holder and make sure the polarities are correctly oriented — the cap side (rimmed rounded
edge) is negative and should be facing the holder; the flat side with a + mark is positive and
should be facing away from the holder.
Safety Measures
• There exists explosion hazard if the battery is incorrectly installed.
• Replace only with the same or equivalent type recommended by the manufacturer.
• Dispose of used batteries according to local ordinances.
Battery
Holder
Battery
X
Internal I/O Connectors
