Emergency Measurement
90
After starting the engine
ABS warning light (if
fitted)
ABS (Antilock Braking System) fault
Refer to ABS System
Implementation of the
braking, ABS warning
light (if fitted)
ABS (Antilock Braking System) fault
Refer to ABS System
9. ABS system failure (optional)
Check 1
Steps
Operation
Yes
No
1
1) When the ignition switches off, remove the
ABS wheel speed sensor.
2
）
Measure the resistance of ABS sensors
between terminal connectors are in the
1.4-1.8KΩ range (at 20 ° C, 68 ° F
environment)
Proceed to step 2
Replace ABS wheel speed sensor
assembly.
2
1
）
Disconnect the ignition switch
2) Disconnect the ABS control module
connectors
3
）
Check first with the sensor and the ABS
control module terminal is properly connected
4
）
If all goes well, then close the ignition
switch and measure the positive voltage
between the sensor terminal of module plug
connector and ground columns, whether the is
OV.
Proceed to step 3
ABS wheel speed sensor cathode
circuit with the power supply short
circuit
Summary of Contents for K 2019 Series
