Emergency Measurement
93
3
1
）
Remove the ABS control module
connector
2
）
Check the ABS control module terminal
"A1",
"A2", "A7", "A8", "B12", "B13", whether the
current valve circuit connected correctly.
2
）
If the connection is good, measure
to-ground voltage of module terminal A1,
A2, A7, A8, B12 or B13- (ignition switch is
closed), to see if it’s OV.
Proceed to step 4
"R", "R / W", "B1", "B1 / W", "Y", or "Y
/ W" short circuits and power supply
4
1
）
Disconnect the ignition switch
2
）
Connect the connectors to the ABS
hydraulic unit.
3
）
Measure the ground resistance of module
terminal A1, A2, A7, A8, B12 or B13, to see
if it’s connected.
With
a
well-known ABS
control
module
replaced
and
re-check
"R", "R / W", "B1", "B1 / W", "Y", or "Y
/ W" circuit is open, poor contact or
short-circuited.
10
、
Power system failure
Problem
Reason
Treatment
Turn on the ignition switch, the
engine is not running, the charging
light does not shine
Fuse blown
Lights burned out
Loose wire connections
IC regulator or field coil failure
Bad brush and slip ring
Check the fuse
Replace Lamp
Tighten fittings
Check the generator
Repair or replacement
Summary of Contents for K 2019 Series
