Page | 2
This document describes DG Technologies VSI-2534. The VSI-2534 is an SAE J2534 Pass-Thru
device with its primary purpose to program automotive ECUs (Electronic Control Units).
The VSI-2534 is also useful for vehicle diagnostics, development, general design, hardware-in-
the-loop simulation and anywhere communications with a vehicle network are required.
Permission is granted to copy any or all portions of this manual, provided that such copies are for use with the VSI-
2534 product and that “© 201
9 DG Technologies
.”, (herein referred to as “Dearborn Group”, “DG Technologies”,
or “DG”), remains on all copies.
The accompanying software, provided for use with the VSI-2534, is also copyrighted. Permission is granted to copy
this software for back-up purposes only.
I M P O R T A N T
To ensure your success with this product, it is essential that you read this document carefully before using the
hardware.
Damage caused by misuse of the hardware is not covered under product warranty. When using this manual, please
remember the following:
❑
This manual may be changed, in whole or in part, without notice.
❑
DG assumes no responsibility for any damage resulting from the use of this hardware and software.
❑
Specifications presented herein are provided for illustration purposes only and may not accurately
represent the latest revisions of hardware, software or cabling.
❑
No license is granted, by implication or otherwise, for any patents or other rights of DG or of any third
party.
DG
® logo is a registered trademark of DG Technologies, Inc. Other products that may be referenced in this manual
are trademarks of their respective manufacturers.
© 2006 - 2019 DG Technologies, Inc.
