Product description StretcherBar and StretcherSling
StretcherSling can only be applied and removed when the patient is lying down
1. Turn the patient towards you. Place
StretcherSling so that the product label is facing
the underlying surface and the sling’s mid-section
follows the patient’s spine.
The upper edge of StretcherSling should support
the head.
Place the edge of the sling as far in under the
patient as possible. Guide the loops under, so that
you can reach them once you have turned the
patient back onto StretcherSling.
2. Turn the patient back onto the sling and pull the
sling out from the other side with the help of the
straps.
3. If necessary: Adjust the width of StretcherBar to
fit the patient’s width by pulling out the lift hooks.
Then, hook the lift loops onto the bar.
4. Raise the lift until all loops are fully extended.
Pause to ensure that everything is as it should be
before raising the patient clear of the underlying
surface.
5. If the patient is not balanced after being lifted
from the underlying surface, this can be corrected
turning the balance regulator.
Removal of the StretcherSling
1. Release all suspension hooks from the lift and
move it out of the way. Turn the patient toward you
and tuck StretcherSling in under itself against the
underlying surface.
2. The fabric slides against itself when you pull out
StretcherSling, after turning back the patient.
5
I F U
System
1
2
3
4
1
2
5