6
I F U
2. Place the patient’s legs at a 90˚ angle with their feet on the floor or plat-
form. Adjust the shin supports to fit the patient’s shins; remember to avoid
pressure on the patellae and patellar tendons.
1. Fit the harness as low as possible across the hips and bottom with the
broad upper part around the hips and the narrow lower part around the
bottom. Attach the strap with buckles and tighten it using the adjustable
safety belt. Note that the lower part of the harness attached around the
patient’s bottom can be opened as required, e.g. for visits to the WC.
Standing up and walk training with MULTI Belt
Because standing up or transporting patients always entails risks we recommend that two people are always pres-
ent to assist the patient at such times.
3. Using Bure Walker
Standing up and walk training
1.
Ask the patient to sit on the edge of the bed or chair. Bring out the walking table and place it in front of the
patient. Lock the brakes on the wheels.
2.
Ask the patient to place their arms on the armrests. If necessary, ask the patient to move forward on the seat
base so that the patient reaches the handles.
3.
Ask the patient to lean forward. To start raising the walking table, press the UP button on the hand control.
Raise the walking table to a desired height.
4.
Unlock the brakes. Adjust the height of the walking table to a desired position
5.
Assist the patient while walk training.
Before use:
•
Inspect the packaging for any damage.
•
Check for correct product being delivered.
•
Check to ensure that the device is free from damage.
•
Check if all the parts/components are included in the packaging.
•
Check if all approved accessories are included in the package.
•
Check if Product Quality Approval document is included in the packaging. Save this document for future
contact with manufacturer.
•
Make certain the device is properly assembled.
•
Check lifting function and bottom-frame adjustment function.
•
Check if it is possible to move the device in all directions.
•
Check the condition and function of the sling/belt regularly. Always inspect the product after laundering. The
occurence of the following must be checked: frays, loose stitches, damage to the fabric, edging, handles,
broken buckles. If any of these points apply, the product should be discarded.
Summary of Contents for SystemRoMedic Bure Rise & Go DB
Page 2: ...2 I F U...
Page 178: ...178 I F U Parts...
