53
EN
DHOLLANDIA
6.13
6.14
G
M
§6.4 - Mounting of the bumper bar
The fixed 3-piece bumper bar S362 has a fixed position on
the HTL frame. Take this position into consideration when
planning on the mounting height C, so that the fitted HTL
complies with legal bumper requirements [See Fig. 6.13].
When using a confirmed FITTING DRAWING,
the bumper height is taken into account when
determining the fitting height C.
Otherwise consult the TECHNICAL SUMMARY of the HTL
to check the technical relation between the fitting height C
and the position of the bumper bar.
It is not allowed to modify (cut, weld, move,…)
the original bumper bar. Disregard could lead to
non-conformity with the bumper bar certificates,
and refusal at the vehicle inspection.
Double-check compliance of the bumper position with the
legal requirements [See Fig. 6.13].
Mount the middle bumper bar section [See Fig. 6.14].
Fasten all bolted connections, and tighten them according
to the required torque settings [See annex].
EX.
EX.
