DHOLLANDIA
51
EN
6.8
§6.3 - Finalize the stow position of the platform
If applicable (option S600-S603), mount the rubber plat-
form seals to the rear frame of the vehicle body. [See Fig.
6.8].
Top & side profile
Floor profile
Steel, alu or inox
ø15
Adjust the stroke of the tilt cylinders type SKM & SKSV
with adjustable extension.
This stroke is adjusted by means of 2 adjustable exten-
sions left & right [1] and 2 locking nuts [2], that are
screwed onto the piston rods [3] of the tilt cylinders [See
Fig. 6.9].
Slide-out the tilt cylinders type to their maximum length
(either by hand, or by using the function “close” on the
electrical control panel).
Loosen the locking nut [2 in Fig. 6.9] with a C-spanner, and
turn the extension around its axis to increase or decrease
the stroke.
Adjust the position of the adjustable extension in such a
way that the centre of the articulation hole in it is max.
5mm longer than the position that the closed platform in
vertical position would require [See Fig. 6.10].
6.9
Máx.
5 mm
6.10
M
1
2
3
A1 Centre of the articulation hole in the extension of the
tilt cylinder
A2 Centre of the articulation hole in the platform hand
A1
A2
