EN
59
DHOLLANDIA
6.10
!
1 bolt /side
M16 - 8.8
195 N.m
1
1
2
1
1
6.11
EX.
EX.
3
3
3
1 End stops for the retraction movement
2 Slide
plates
3 Sliding
tubes
•
The same bridge plate can also be used on container
chassis, to adapt the platform to varying container sizes &
positions.
•
2 end stops at the rear of the sliding tubes ensure that the
platform assumes the same stable work position, every
new time the HTL is used [See 1 in Fig. 6.10].
•
Lift the platform up to the loading floor of the vehicle, and
set it in the intended work position, as explained above
[See Fig. 6.10].
•
Insert the end stops [1 in Fig. 6.10] in the slid-
ing tubes. Move them to the work position of
the slide plates in the sliding tubes. Fasten the
locking bolt of the end stops to the required
torque settings [See Fig. 6.11].
•
Slide the HTL in / out several times, to verify if the plat-
form assumes the correct work position at the loading
floor of the vehicle. Fine-tune the position of the end stops
if required.
2
M
Summary of Contents for DH-SM(R).20
