SET-UP AND ADJUSTMENT OF THE DI-ACRO QUIK-LOK
In order to provide sufficient clamping pressure for bending with a Quik-Lok, it must be set up
properly. Failure to follow these instructions may result in poor performance from your Di-Acro
bender.
NOTE: Read the entire procedure prior to setting up the Quik-Lok. A Model 2 bender is shown
throughout this procedure. All other Quik-Lok assemblies will be set up in the same manner.
1. Place the desired radius collar on your bender, and mount the Quik-Lok assembly so that the
clamp block is parallel with the flat side of the radius collar, as shown in Figure 1, below. Leave
the bolts slightly loose for now.
Figure 1: Proper Quik-Lok placement
