3. Loosen the hold-down bolt on the hanger, and adjust the knurl head screw in or out until the
clamp block touches the radius collar. Note that you may need to change the spacer rods
and/or move the hold-down bolt to another hole in the Quik-Lok base to achieve this position.
Tighten the knurl head screw until it becomes hard to turn. Tighten the bolts for the Quik-Lok
base and the hold down bolt in the hanger at this time.
Figure 3: Clamping pressure adjustment
The Quik-Lok is now adjusted properly for Di-Acro tooling. Unclamp the Quik-Lok by indexing
the Handle Rod away from the bender. Now adjust the forming nose or roller and start bending!
Di-Acro
12430 55
th
Street North
Oak Park Heights, MN 55082
www.diacro.com
