REPLACING THE FUSES
1. Disconnect the test leads from the meter and any item under test.
2. Open the fuse cover by loosening the screw on the cover using a
Phillips head screwdriver.
3. Remove the old fuse from its holder by gently pulling it out.
4. Install the new fuse into the holder.
5. Always use a fuse of the proper size and value (0.2A/250V fast
blow for the 200mA range, 10A/250V fast blow for the 10A
range).
6. Put the fuse cover back in place. Insert the screw and tighten it
securely.
WARNING:
To avoid electric shock, disconnect the test leads
from any source of voltage before removing the fuse cover.
WARNING:
To avoid electric shock, do not operate your meter
until the fuse cover is in place and fastened securely.
24 Month Warranty
Di-Log instruments are subject to stringent quality
controls. If in the course of normal daily use a fault
occurs we will provide a 24 month warranty (only
valid with invoice). Faults in manufacture and
materials defect will be rectified by us free of charge,
provided the instrument has not been tampered with
and returned to us unopened. Damage due to
dropping abuse or misuse is not covered by the
warranty.
Outside the warranty period we offer a full repair and
re-calibration service.
Di-Log Test Equipment
28 Wheel Forge Way
Trafford Park
Manchester
M17 1EH
UK
Tel + 44 161 877 0322
Fax + 44 161 877 1614
Website: www.dilog.co.uk
Email: sales@dilog.co.uk
14
15
