MCQ-PRO RFID Reader
— Installation and Tuning Manual Version 1.00
Page 61 of 89
If Application Identifier (in hexadecimal) is not null, only tags with the same identifier
will reply.
A null value disables the family code or the application identifier.
9.3.2
Memory and State tab
Figure 51: I-Code 1 panel (Memory and State tab)
Tag Selection
Tag selection is mandatory before performing read, write or halt commands.
To select tags in radio field, click “AutoSelect Tags” button. Each selected tag is affected to a
distinct time slot and displayed in the list.
The number of time slots defined in I-Code parameters (see section 9.1.1) is used
while performing tag selection. If there were not enough time slots available to
select all tags, you should try to change this setting to a higher number or to
remove some tags from radio field.
Read Operation
To perform selected read, choose one or several tags from “Tag Selection” list, enter the first
block and the number of blocks to read and click “Select. Read”.
Write Operation
To perform selected write, choose one or several tags from “Tag Selection” list, enter the
block and the data (in hexadecimal) to write and click “Selected Write”.
Summary of Contents for MCQ-PRO
Page 1: ...User Manual Version 1 00...
