Fine tuning the CX Video Gateway configurationDialogic® Vision™ CX Video Gateway Administration Manual
Fine tuning the media board configuration
To fine tune the media board configuration for the CX Video Gateway, modify the
following media board configuration files:
•
oamsys.cfg
•
Media board configuration files
These files reside in the
vx/callserver/conf/cg
directory.
oamsys.cfg file
The
oamsys.cfg
file that ships with the CX Video Gateway includes placeholders
within <> brackets, such as
<IP_CG_0>
. Replace these placeholders with
appropriate values. The values that do not have brackets are default values that you
can replace, if necessary.
Specify the following settings in the
oamsys.cfg
file to configure the media boards:
Keyword
What to do
IPC.AddRoute[0].DestinationAddress
Replace
<IP-CG_0>
with the IPv4 address for the media board
Ethernet interface.
IPC.AddRoute[0].Mask Replace
<SUBNET_MASK
>
with the subnet mask for the IPv4
address specified in IPC.AddRoute[x].DestinationAddress.
IPC.AddRoute[0].Interface
Specify 2 in place of 1
to associate
Ethernet interface 2 with
IPv4 connections.
Leave the default 1 to associate Ethernet interface 1 with IPv4
connections.
IPC.AddRoute[1].gatewayAddress
Replace
<GATEWAY_IP>
with the IPv4 address of the router.
If the gateway is configured to use two media boards, specify the settings for the
second media board. The setting names are the same, except that
<IP_CG_1>
indicates the IPv4 address of the second media board.
The following example shows the settings in the
oamsys.cfg
file for a CX Video
Gateway with two media boards:
112
Dialogic
